Multi-Objective Optimization of the Inconel 718 Turning Parameters Using MARCOS–Based Taguchi S/N ratio
Öz
Nickel-based alloys, such as Inconel 718, are widely used in space technology, rocket engines, nuclear reactors, petrochemicals, submarines, power plants, and other applications. It is classified as a challenging material to process due to its strong mechanical properties, low thermal conductivity, and other characteristics. The main objective of this work is to determine the optimal cutting parameters for turning Inconel 718 using a coated carbide tool, with the aim of reducing cutting tool vibration, minimizing surface roughness, and maximizing material removal rate. This is achieved by employing the Measurement of Alternatives and Ranking according to Compromise Solution technique (MARCOS) coupled with Taguchi's signal-to-noise ratio. The results have demonstrated that the configuration of the cutting parameters for achieving the aforementioned objectives is as follows: r = 0.8 mm, Vc = 70 mm/min, f = 0.08 mm/rev, and ap = 0.3 mm.
Anahtar Kelimeler
Kaynakça
- Alsoruji, G., Muthuramalingam, T., Moustafa, E. B., & Elsheikh, A. (2022). Investigation and TGRA based optimization of laser beam drilling process during machining of Nickel Inconel 718 alloy. Journal of Materials Research and Technology, 18, 720–730.
- Amigo, F.J., Urbikain, G., &de Lacalle, L.N.L. (2023).On the effects of cutting-edge angle on high-feed turning of Inconel 718© superalloy. International Journal of Advanced Manufacturing Technology, 125, 4237–4252.
- Arunramnath, R.,Thyla, P. R., Mahendrakumar, N., Ramesh, M.,&Siddeshwaran, A. (2019).Multi-attribute optimization of end milling epoxy granite composites using TOPSIS. Journal of Materials and Manufacturing Process, 34(5), 530–543.
Öz
Kaynakça
- Alsoruji, G., Muthuramalingam, T., Moustafa, E. B., & Elsheikh, A. (2022). Investigation and TGRA based optimization of laser beam drilling process during machining of Nickel Inconel 718 alloy. Journal of Materials Research and Technology, 18, 720–730.
- Amigo, F.J., Urbikain, G., &de Lacalle, L.N.L. (2023).On the effects of cutting-edge angle on high-feed turning of Inconel 718© superalloy. International Journal of Advanced Manufacturing Technology, 125, 4237–4252.
- Arunramnath, R.,Thyla, P. R., Mahendrakumar, N., Ramesh, M.,&Siddeshwaran, A. (2019).Multi-attribute optimization of end milling epoxy granite composites using TOPSIS. Journal of Materials and Manufacturing Process, 34(5), 530–543.
Ayrıntılar
| Birincil Dil | İngilizce |
|---|---|
| Konular | Çevresel ve Sürdürülebilir Süreçler |
| Bölüm | Makaleler |
| Yazarlar | |
| Erken Görünüm Tarihi | 26 Aralık 2023 |
| Yayımlanma Tarihi | 30 Aralık 2023 |
| Yayımlandığı Sayı | Yıl 2023Cilt: 26 |
Kaynak Göster
